I fired up my old beast last night, a v20 640k with a herc card, I ran my
compiled copy of microwin with herc support, and it worked!
WELL done to greg and whoever helped write that driver!
On the down side it did take a little long for it to load, try 10 min!
So if it is to be used the code has to be somewhat speeded up. I did not try
to move any windows because I did not have a mouse pluged in and it would
have taken too long.
I am not realy an expert, but a v20 is faster that an 8086/8088 so it might
be worse on those. All that I can think of doing is 1.adding 8087 support
2.speeding up code 3. anyone else have ideas??
From
Thomas Stewart :-)
at [EMAIL PROTECTED]
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
