> Hi,
>
> Dwayne Jacques Fontenot wrote:
>
> > everything you said is perfectly logical. however, for some reason
> > I cannot get 4 different IRQs to appear on the PCI bus. PCI1 always
> > has the same IRQ as PCI4,5. I did manually assign 11,10,9,5 in the
> > BIOS but I only get 11,10 and 9.
>
> This means your IRQ 5 is already dealt off for an onboard ISA or PnP ISA
> device.
> Lock into the CMOS setup for the COM1, COM2, LPT settings if you really
> don't have any ISA PnP card.
> A good idea is to "pause" the display at the LILO prompt and look into
> the PCI device table you see then.
I will take a look. I don't have any ISA cards, but I guess the LPT could
be using IRQ 5 (though I also tried 7 without success).
> > 00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01) (prog-if 00
>[UHCI])
> > Flags: bus master, medium devsel, latency 32
> > I/O ports at c000
>
> No irq mentioned here - disabled in CMOS setup?
>
> > 00:07.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 02)
> > Flags: medium devsel
>
> Disabled, too?
Yes, both USB and ACPI are disabled in the BIOS since I don't use them.
BTW, I finally got everything working last night. The pci busmastering
in slots 4 and 5 was the key. I have slot 4 empty now.
AFAICT, es1371 and PCI TNT share well, as do es1371 and FA310TX.
The latter is how I have it now - used it all night without incident.
THANKS EVERYBODY!
Dwayne
> Cheers -e
> --
> Eberhard Moenkeberg ([EMAIL PROTECTED], [EMAIL PROTECTED])
--
=- To unsubscribe, email [EMAIL PROTECTED] with the -=
=- body of "unsubscribe linux-abit". -=
