The current code is clearing in_lpm flag after enabling the IRQ. If IRQ comes immediately before in_lpm flag is set, it thinks that hardware is in low power mode and disables the IRQ. Fix this by clearing in_lpm flag before enabling the IRQ.
Signed-off-by: Pavankumar Kondeti <[email protected]> --- drivers/usb/otg/msm_otg.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/usb/otg/msm_otg.c b/drivers/usb/otg/msm_otg.c index 2965986..f58b7da 100644 --- a/drivers/usb/otg/msm_otg.c +++ b/drivers/usb/otg/msm_otg.c @@ -389,14 +389,14 @@ skip_phy_resume: if (bus) set_bit(HCD_FLAG_HW_ACCESSIBLE, &(bus_to_hcd(bus))->flags); + atomic_set(&motg->in_lpm, 0); + if (motg->async_int) { motg->async_int = 0; pm_runtime_put(otg->dev); enable_irq(motg->irq); } - atomic_set(&motg->in_lpm, 0); - dev_info(otg->dev, "USB exited from low power mode\n"); return 0; -- Sent by a consultant of the Qualcomm Innovation Center, Inc. The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum. -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
