Hi Kiran,

On Fri, 2014-09-19 at 15:49 +0530, Kiran Padwal wrote:
> Hi Ivan,
> 
> On Thursday 18 September 2014 06:45 PM, Ivan T. Ivanov wrote:
> > The current ADC is peripheral of Qualcomm SPMI PMIC chips. It has
> > 16 bits resolution and register space inside PMIC accessible across
> > SPMI bus.
> > 
> > The driver registers itself through IIO interface.
> > 
> > Signed-off-by: Ivan T. Ivanov <iiva...@mm-sol.com>
> > ---
> >  .../devicetree/bindings/iio/adc/qcom,spmi-iadc.txt |  61 ++
> 
> <snip>
> 
> > diff --git a/drivers/iio/adc/Kconfig b/drivers/iio/adc/Kconfig
> > index 11b048a..77274e4 100644
> > --- a/drivers/iio/adc/Kconfig
> > +++ b/drivers/iio/adc/Kconfig
> > @@ -279,4 +279,15 @@ config XILINX_XADC
> >       The driver can also be build as a module. If so, the module will be 
> > called
> >       xilinx-xadc.
> >  
> > +config QCOM_SPMI_IADC
> > +   tristate "Qualcomm SPMI PMIC current ADC"
> > +   select REGMAP_SPMI
> > +   depends on IIO
> 
> May be you need to add "SPMI" in depends on because without enabling that it 
> breaks.

Right. 

> 
> > +   help
> > +     This is the IIO Current ADC driver for Qualcomm QPNP IADC Chip.
> > +
> > +     The driver supports single mode operation to read from upto seven 
> > channel
> > +     configuration that include reading the external/internal Rsense, 
> > CSP_EX,
> > +     CSN_EX pair along with the gain and offset calibration.
> > +
> >  endmenu
> 
> <snip>
> 
> > +
> > +   return iadc_write(iadc, IADC_EN_CTL1, data);
> > +}
> > +
> > +static void iadc_status_show(struct iadc_chip *iadc)
> > +{
> > +   u8 mode, sta1, chan, dig, en, req;
> 
> During compilation, getting a waring as below for all variables,
> 
> rivers/iio/adc/qcom-spmi-iadc.c: In function ‘iadc_poll_wait_eoc’:
> drivers/iio/adc/qcom-spmi-iadc.c:227:10: warning: ‘en’ may be used 
> uninitialized in this function [-Wmaybe-uninitialized]
>   dev_warn(iadc->dev,
>           ^
> 

Right. I am not sure why I am not getting this warning.

> > +   int ret;
> > +
> > +   ret = iadc_read(iadc, IADC_MODE_CTL, &mode);
> > +   if (ret < 0)
> > +           return;
> > +
> > +   ret = iadc_read(iadc, IADC_DIG_PARAM, &dig);
> 

Thank you for review.

Regards,
Ivan

--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to