"Leonard Ye" wrote:
>Hi all,
>
>Currently, the SA1111 board is using a SMSC9196 ethernet controller which only
> supports 10 BASE-T. This chip is supported by ARM linux using the driver for
> SMC9194. However, I would like to know is it possible to improve the speed o
>f this ethernet interface to 10/100 BASE-T. For an example, make a new board
>which is exactly the same as this SA1111 board but replacing this SMSC9196 chi
>p with another compatible chip such that no/minor driver change is needed. Cu
>rrently, SMSC91C100 and SMSC91C110 from SMC support 100 BASE-T. But I don't kn
>ow whether they are compaitible with SMSC91C96.
Well, you could certainly make the existing 9196 interface 16 bit. That
would have an effect on throughput... :-)
-brad
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
