Hi all, I am doing a feasibility investigation of SA1110/1111 development platform. I would like to know that under ARM Linux 2.4.0, is it possible to have the following three devices working at the same time: 1) UART1 of neponset connected to a standard modem so that I can dial out through UART1 2) UART3 of neponset, used as a debug port to a console 3) SMC91C96 ethernet controller, connected to a wired network. The main problem I am worry about is that, from the SA1111 User guide, page 4-8, bit 3 of the Modem Control Register MDM_CTL_0, which is defined as DTR2 is used for enabling the ethernet oscillator. Will there be any implementation conflicts? Thanks in advance. Regards, Leonard Ye _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm Please visit the above address for information on this list.
