If you don't have neponset present,skip this mail.
Subject:Blob Problem
>I am using BLOB.But I am getting this problem.
>Starting kernel...Uncompressing Linux...done.Booting the kernel.
>Here it hangs
I think it doesn't hang.
If you get the prompt " blob > " on ttyS0, You should
start another minicom connected ttyS1 (neponset UART3)
on another virtual terminal. After your typing:
blob > boot
You can see boot messages from ttyS1.
Try it!. Good luck!
Fengcai
______________________________________
===================================================================
������ѵ������� (http://mail.sina.com.cn)
����Ѱ��ǧ�ٶ�!û��"��������",����"��˫�ɶ�"? (http://newchat.sina.com.cn)
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
