> Hi,
> I am getting the same message
> blob>boot
> Uncompressing the kernel.........done.Booting the kernel.
> and here it hangs.
> I have disabled frame buffer and passed the initrd parameters as u
said.But
> the
> same kernel works properly with Angel.One thing was that when the kernel
was
> loaded
> the LED D8 was constantly blinking and D9 very little.So earlier also the
> LED's did not blink
> But I have not upgraded the kernel I will try it now.But atleast the
kernel
> must boot know?
>
> Does it have anything to do with the kernel parameter passing?
> Thanx,
> hari\
> ----- Original Message -----
> From: Erik Mouw <[EMAIL PROTECTED]>
> To: Hari <[EMAIL PROTECTED]>
> Sent: Friday, March 30, 2001 1:43 PM
> Subject: Re: Assabet
>
>
> > On Fri, Mar 30, 2001 at 12:52:27PM +0530, Hari wrote:
> >
> > Don't send mail to me personal if you followup from a mailing list.
> > I like the others to be able to correct me if I'm wrong.
> >
> > > I am using kernel 2.4.0 ,and I have followed the instructions in the
> > > web site www.cs.cmu.edu/~wearable/software/assabet.html .
> > > We used Angel boot.In the kernel configuration
> > > I am sending my .config file ALONG with this mail.I have patched with
> the
> > > patches given in the site. We could port the same kernel with the
Angel
> > > enabled on to assabet and we are getting a prompt on the serial Port.
> > > But we would like to boot from the flash ,and hence we are going with
> blob.
> > > But in blob we are getting this message
> > > Uncompressing the kernel................
> > > done Booting tjhe kernel here it hangs.
> >
> > Your kernel is perfectly well. What is wrong is that you enabled the
> > frame buffer device so the kernel uses that as console and prints all
> > messages over there. In order to fix that, you need to change
> > CONFIG_CMDLINE from "keepinitrd" to "keepinitrd console=ttyS0,9600".
> > And upgrade to linux-2.4.2-rmk1-np3, the 2.4.0 based kernels have some
> > known bugs.
> >
> >
> > Erik
> >
> > > Thanx ,
> > > hari
> >
> > > #
> > > # Automatically generated make config: don't edit
> > > #
> >
> > (oh, and next time you include a config file: include the output of
> > "grep '^CONFIG' configgile", that makes it a lot smaller)
> >
> > --
> > J.A.K. (Erik) Mouw, Information and Communication Theory Group,
Department
> > of Electrical Engineering, Faculty of Information Technology and
Systems,
> > Delft University of Technology, PO BOX 5031, 2600 GA Delft, The
> Netherlands
> > Phone: +31-15-2783635 Fax: +31-15-2781843 Email:
> [EMAIL PROTECTED]
> > WWW: http://www-ict.its.tudelft.nl/~erik/
> >
>
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
