On Sun, Apr 29, 2001 at 02:18:54PM +0800, kittenwang wrote:
> Who can tell me what should be done before running a linux kernel on a arm based
>handheld.
> The handhelds.org has successfully boot linux from flash on ipaq.Now, I want to
>boot linux as wince running.That is:
> 1.prepare a kernel image on CF card.
> 2.run a program to load the kernel.(cyace for arm)
> 3.linux kernel take the control...
> And, somebody has done this on mips based handheld.They used another cyace for mips.
> But, when I boot up the kernel, it suspend on trap_init().Since, the kernel should
>be right, I think the fault is in the cyace.Perhaps, the cyace does not prepare all
>things right for the linux kernel.
> So, I want to know what should be done before the linux kernel run.Which mode
>should we use, system or superviser?What are the contens of those special register?
> Please help me!
> Best wishes!
Stop sending the same question over and over again. If you don't get an
answer on your question it usually means nobody knows the answer, or
that the people that do know are sleeping, enjoying their
weekend/holidays/whatever.
Erik
--
J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department
of Electrical Engineering, Faculty of Information Technology and Systems,
Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands
Phone: +31-15-2783635 Fax: +31-15-2781843 Email: [EMAIL PROTECTED]
WWW: http://www-ict.its.tudelft.nl/~erik/
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
