Hello.
I can boot normally with ramdisk, but cannot use CF LP-E network card on the
assabet.
Cardmgr shows nothing, cardctl status shows 3.3v card, but in "ident" -
nothing found
at ifconfig I see only "lo".
Here's my configuration:
Assabet rev 8 board.
Blob 1.08 pre-2
Linux kernel - 2.4.3 -rmk2-np1
Ramdisk_ks (warable group), with little changes:
The dir. /lib/modules/2.4.0...replaced with the name of the kernel version:
/lib/modules/2.4.3-rmk....
I've Added ALL the compiled modules of "net/pcmcia" section to this dir.
(I also tried the whole assabet-blob-kit-1.3 but no use either)
Kernel configured With these options:
make assabet_config
make neponset_config
make oldconfig
---------------------
make xconfig
sections:
29/5/01 12:14: - gad setup
general setup - N - angel support
MTD -
Y - mtd support
Y - mtd partitooning supp.
Y - direct char device
Y - caching block device
Ram/rom/flash chip drivers -
Y - CFI supp.
Y - CFI supp. for intel/sharp ext. commands
mapping drv. for chip access
Y - CFI mapping on StrongArm
block devices -
Y - loopback
networking options -
Y - kernel httpd (net/khttpd)
Y - packet socket
Y - ip multicasting
network device support:
pcmcia:
Y - pcmcia device support
M - all others, except wireless lan
Y - NE2000 ... support
Character devices: (1 to 4 enabled)
Y - supp. for console on vir. terminal
Y - std/generic serial (8250/16550) supp
Y - supp. for console on ser. port
file systems -
Y - supp. for JFFS
Y - supp. for JFFS 2
Y - simple ram fs supp. (RAMFS)
sound -N
usb -N
SAVE AND EXIT
-------------------------------
make dep clean zImage modules
-------------------------------
if I connect neponset (sa1111), and work from the assabet flash, I can use
only the SMC (built -in ethernet port) on the neponset (with dummy 12345 HW
address), but cannot use the big PCMCIA card (here it recognize it, I see it
in ifconfig - and I see regular HW address (not 12345...) but no ident ,no
ping and no light on the hub !)
I cannot use either the CF -LP-E card (the same problem as before with the
assabet only)
here's my dmesg and /var/log/messages:
------------------------------------------------------------------
DMESG:
[root@Linux /root]$dmesg
Linux version 2.4.3-rmk2-np1 (root@Linux-Doron) (gcc version 2.95.2 19991024
(re
lease)) #2 Tue May 29 12:24:46 IDT 2001
Processor: Intel StrongARM-1110 revision 8
Architecture: Intel-Assabet
Neponset expansion board detected
Warning: bad configuration page, trying to continue
On node 0 totalpages: 8192
zone(0): 256 pages.
zone(1): 7936 pages.
zone(2): 0 pages.
Kernel command line: keepinitrd
Console: colour dummy device 80x30
Calibrating delay loop... 207.66 BogoMIPS
Memory: 32MB = 32MB total
Memory: 27256KB available (1483K code, 296K data, 76K init)
Dentry-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 2048 (order: 2, 16384 bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
SA-1111 Microprocessor Companion Chip: silicon revision 1, metal revision 1
scale: SA-1110 clock scaling initialized, clock speed is 221 MHz
Starting kswapd v1.8
Console: switching to colour frame buffer device 40x30
Keyboard timed out[1]
initialize_kbd: Keyboard reset failed, no ACK
pty: 256 Unix98 ptys configured
Keyboard timed out[1]
keyboard: Timeout - AT keyboard not present?
Keyboard timed out[1]
keyboard: Timeout - AT keyboard not present?
block: queued sectors max/low 17842kB/5947kB, 64 slots per queue
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
smc9194.c:v0.14 12/15/00 by Erik Stahlman ([EMAIL PROTECTED])
SMC9194: uninitialized MAC address detected -- using a dummy one
eth0: SMC91C96(r:9) at 0xc2829000 IRQ:104 INTF:TP MEM:6144b ADDR:
00:01:02:03:04
:05
RAMDISK: Compressed image found at block 0
JFFS version 1.0, (C) 1999, 2000 Axis Communications AB
JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications
AB.
loop: loaded (max 8 devices)
Serial driver version 5.05 (2000-12-13) with no serial options enabled
SA1100 serial driver version 1.3
ttyS0 on SA1100 UART3 (irq 17)
ttyS1 on SA1100 UART1 (irq 15)
ttyS2 on SA1100 UART2 (irq 16), using IRDA
UCB1200 generic module installed
ucb1200 touch screen driver initialized
SA1100 flash: probing for 3 partitions (buswidth = 4)
SA1100: Found 2 x16 devices at 0x0 in 32-bit mode
JEDEC ID: 89 18
0: offset=0x0,size=0x40000,blocks=128
SA1100 flash access initialized
Linux PCMCIA Card Services 3.1.22
options: none
SA-1100 PCMCIA (CS release 3.1.22)
mice: PS/2 mouse device common for all mice
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 2048)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NetWinder Floating Point Emulator V0.95 (c) 1998-1999 Rebel.com
VFS: Mounted root (ext2 filesystem).
Freeing init memory: 76K
-----------------------------------------------------------------
/var/log/messages
[root@Linux /root]$cat /var/log/messages
Jan 1 00:00:08 Linux klogd started: BusyBox v0.43 (20000404-0124)
Jan 1 00:00:08 Linux kern.warn Linux version 2.4.3-rmk2-np1
(root@Linux-Doron)
(gcc version 2.95.2 19991024 (release)) #2 Tue May 29 12:24:46 IDT 2001
<4>Processor: Intel StrongARM-1110 revision 8
<4>Architecture: Intel-Assabet
<4>Neponset expansion board detected
<4>Warning: bad configuration page, trying to continue
<4>On node 0 totalpages: 8192
<4>zone(0): 256 pages.
<4>zone(1): 7936 pages.
<4>zone(2): 0 pages.
<4>Kernel command line: keepinitrd
<4>Console: colour dummy device 80x30
<4>Calibrating delay loop... 207.66 BogoMIPS
<6>Memory: 32MB = 32MB total
<5>Memory: 27256KB available (1483K code, 296K data, 76K init)
<4>Dentry-cache hash table entries: 4096 (order: 3, 32768 bytes)
<4>Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
<4>Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
<4>Inode-cache hash table entries: 2048 (order: 2, 16384 bytes)
<4>POSIX conformance testing by UNIFIX
<6>Linux NET4.0 for Linux 2.4
<6>Based upon Swansea University Computer Society NET3.039
<6>SA-1111 Microprocessor Companion Chip: silicon revision 1, metal revision
1
<6>scale: SA-1110 clock scaling initialized, clock speed is 221 MHz
<4>Starting kswapd v1.8
<4>Console: switching to colour frame buffer device 40x30
<4>Keyboard timed out[1]
<4>initialize_kbd: Keyboard reset failed, no ACK
<4>pty: 256 Unix98 ptys configured
<4>Keyboard timed out[1]
<4>keyboard: Timeout - AT keyboard not present?
<4>Keyboard timed out[1]
<4>keyboard: Timeout - AT keyboard not present?
<4>block: queued sectors max/low 17842kB/5947kB, 64 slots per queue
<4>RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
<6>Uniform Multi-Platform E-IDE driver Revision: 6.31
<4>ide: Assuming 50MHz system bus speed for PIO modes; override with
idebus=xx
<4>smc9194.c:v0.14 12/15/00 by Erik Stahlman ([EMAIL PROTECTED])
<4>SMC9194: uninitialized MAC address detected -- using a dummy one
<4>eth0: SMC91C96(r:9) at 0xc2829000 IRQ:104 INTF:TP MEM:6144b ADDR:
00:01:02:03
:04:05
<5>RAMDISK: Compressed image found at block 0
<4>JFFS version 1.0, (C) 1999, 2000 Axis Communications AB
<5>JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis
Communications AB
.
<6>loop: loaded (max 8 devices)
<6>Serial driver version 5.05 (2000-12-13) with no serial options enabled
<4>SA1100 serial driver version 1.3
<4>ttyS0 on SA1100 UART3 (irq 17)
<4>ttyS1 on SA1100 UART1 (irq 15)
<4>ttyS2 on SA1100 UART2 (irq 16), using IRDA
<4>UCB1200 generic module installed
<4>ucb1200 touch screen driver initialized
<5>SA1100 flash: probing for 3 partitions (buswidth = 4)
<6>SA1100: Found 2 x16 devices at 0x0 in 32-bit mode
<4>JEDEC ID: 89 18
<4>0: offset=0x0,size=0x40000,blocks=128
<5>SA1100 flash access initialized
<6>Linux PCMCIA Card Services 3.1.22
<6> options: none
<6>SA-1100 PCMCIA (CS release 3.1.22)
<6>mice: PS/2 mouse device common for all mice
<6>NET4: Linux TCP/IP 1.0 for NET4.0
<6>IP Protocols: ICMP, UDP, TCP, IGMP
<4>IP: routing cache hash table of 512 buckets, 4Kbytes
<4>TCP: Hash tables configured (established 2048 bind 2048)
<6>NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
<4>NetWinder Floating Point Emulator V0.95 (c) 1998-1999 Rebel.com
<4>VFS: Mounted root (ext2 filesystem).
<4>Freeing init memory: 76K
Jan 1 00:00:08 Linux syslogd started: BusyBox v0.43 (20000404-0124)
Jan 1 00:00:08 Linux local7.notice syslog: syslogd startup succeeded
Jan 1 00:00:10 Linux local7.notice ifup:
/etc/sysconfig/network-scripts/ifup-po
st: cd: /var/run/netreport: No such file or directory
Jan 1 00:00:10 Linux local7.notice network: Bringing up interface lo
succeeded
Jan 1 00:00:10 Linux local7.notice portmap: portmap startup succeeded
Jan 1 00:00:10 Linux local7.notice pcmcia: Starting PCMCIA services:
Jan 1 00:00:10 Linux local7.notice pcmcia: cardmgr.
Jan 1 00:00:10 Linux local7.notice rc: Starting pcmcia succeeded
Jan 1 00:00:10 Linux daemon.info cardmgr[124]: starting, version is 3.1.11
Jan 1 00:00:10 Linux daemon.info cardmgr[124]: watching 2 sockets
Jan 1 00:00:10 Linux daemon.info cardmgr[124]: Card Services release does
not m
atch!
Jan 1 00:00:10 Linux daemon.info cardmgr[124]: initializing socket 1
Jan 1 00:00:10 Linux daemon.info cardmgr[124]: socket 1: Anonymous Memory
Jan 1 00:00:11 Linux daemon.info cardmgr[124]: module
/lib/modules/2.4.3-rmk2-n
p1/pcmcia/memory_cs.o not available
Jan 1 00:00:12 Linux daemon.info cardmgr[124]: get dev info on socket 1
failed:
Resource temporarily unavailable
----------------------------------------------------------------------------
(the module memory_cs.o is not on the kernel tree at all ! only in the 2.2
tree of my redhat host system (RH 6.2))
thanks a lot
Doron
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
