I occasionally had problems like this in the past... i don't see them anymore, but that may be because i rarely power down my assabet. The easiest way to make this go away is to not power down the board. If you want to reboot it, type 'reboot'
Gad Hayisraeli wrote: > when i reset the assabet board with the small blue button, or when i > unplug the power, most of the time i cannot boot the machine at all. > > even if i wait a few minutes to the capacitor to discharge (and no, > i do not have a battery plugged in) - it won't load at all. just after > many power-ups on and off again and again - i see the big red D9 > led , and see the board booting. > > is it a hardware malfunction ? is there any way to avoid this > problem ? > > my config: Assabet rev.8 board redboot zImage-2.4.6-rmk2-np1 pcmcia > services 3.1.22 sample.jffs2 (of nico's) > > thanks, > > Gad > > > > _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm > > Please visit the above address for information on this list. > > -- Duncan Palmer [EMAIL PROTECTED] Software Design Engineer Phone: +353-1-2911561 Silicon and Software Systems Fax: +353-1-2911001 _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm Please visit the above address for information on this list.
