The relevant portion of the transcript from /proc/kmsg says: register_serial():autoconfig failed serial_cs: register_serial() at 0xf60002e8, irq 98 failed.
That's all. I added a -v to cardmgr startup opts, but it did not create any additional info. Do IRQs need to be shared?? The card is a 10/100 + 56K modem. (another strange thing: cardctl ident reports the card as function 2: Serial... Shouldn't it be a multifunction card??) Thanks Tim On Mon, Feb 11, 2002 at 06:30:11AM -0500, [EMAIL PROTECTED] wrote: > However, Cardmgr seems to only see the modem half of the card. Are any kernel messages issued when you insert the card? What about cardmgr debug messages (you probably need to change your syslog configuration to display these, or kill of syslogd). > Even then, register_serial() fails when setting an irq 98. How does it fail? More information please. > (Note, I also tried binding pcnet_cs rather than xirc2ps_cs > in /etc/pcmcia/config in event that it might be NE2000 compat, > but that did not work either). Err, if its 100base, then there is no way it could be NE2000. _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm http://www.arm.linux.org.uk/armlinux/mailinglists.php Please visit the above addresses for information on this list. -------------------------------------------------------------------- mail2web - Check your email from the web at http://mail2web.com/ . _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm http://www.arm.linux.org.uk/armlinux/mailinglists.php Please visit the above addresses for information on this list.
