Hello all!
I'm trying to setup my Brutus board to run the basic test programs that
come with the Kit (requires the SDT 2.50 to run, which I have) and I am
not even sure that my Brutus is working. From all the documentation I've
read (what little is provided) connecting the null-modem cable to J23 on
the Brutus and to a COM port on the PC should at least bring up a message
about Angel running on Brutus, right?
I used 9600,8,N,1 and 115200,8.N,1 for the serial port settings yet when I
turned Brutus on, I didn't get anything. I'm certain the PC is fine, the
serial port is fine, the null modem cable is fine, I've checked those
things out. I also made sure all the dip swtiches were in the default
position specified in the .pdf documentation for Brutus. Any ideas?
I haven't gotten to using angelboot.tgz or putting my RAM DISK on there or
anything like that.
For the ARM SDT 2.5 portion, I was using Win95 OSR2.
I'm running Red Hat 6.0 for the Linux end of things, hopefully if my
Brutus is working I can get it to boot Linux...
I'd appreciate any help/suggestions.
Thanks, Vasant.
unsubscribe: body of `unsubscribe linux-arm' to [EMAIL PROTECTED]
