I have made the chages in the Makefile in gdb directory. After that in
directory rdi-share i executed the following commands:
./configure
make
And when i gave the instruction target rdi /dev/ttyS0 in gdb, it is still
saying that it cannot recognize the rdi command.
regards,
-lavu sridhar
On Wed, 24 May 2000, Jungjun Kim wrote:
>The reason why this happens is that gdb5.0 doesn't include RDI stuffs.
>You need to change gdb/Makefile as follows,
>
>for gdb/Makefile
>
> 609 DEPFILES = $(TDEPFILES) $(XDEPFILES) $(SER_HARDWIRE) $(NATDEPFILES) \
> 610 $(REMOTE_OBS) $(SIM_OBS) $(CONFIG_OBS) remote-rdi.o
>
> 783 gdb$(EXEEXT): main.o libgdb.a rdi-share/libangsd.a $(ADD_DEPS) $(CDEPS)
>$(TDEPLIBS)
>
>and change directory to gdb/rdi-share, make configuration, and run 'make',
>then you get libangsd.a library.
>
>I don't know why they don't include this target .
>
>Jungjun Kim
>
>> Thank you for the info. I have the ANGEL Debugger running on the board.
>> Next I tried the command u specified: but it says undefined target
>> commmand rdi. Next I tried the command: target remote /dev/ttyS0 , but I
>> get the message saying could not open connectoin with the remote target.
>>
>> What is the solution to the problem?
>>
>> Regards,
>> Lavu Sridhar
>>
unsubscribe: body of `unsubscribe linux-arm' to [EMAIL PROTECTED]
++ Please use [EMAIL PROTECTED] for ++
++ kernel-related discussions. ++
