Hi all...
I have a brutus board without angel.
I'm trying to load zImage using BLOB.
I successfully downloaded kernel and then running good,
checked by LED.
My problem is that I can't see any messages from serial console
after the control jumped kernel.
like this :
------------------------------------------------------------
blob> download kernel
Switching to 115200 baud
You have 60 seconds to switch your terminal emulator to the same speed and
start downloading. After that blob will switch back to 9600 baud.
..............................................
(Please switch your terminal emulator back to 9600 baud)
Received 262588 (0x000401BC) bytes.
blob>
blob>
blob>
blob>
blob> boot
Starting kernel ...
------------------------------------------------------------
I didn't use angel, just use blob.
Is there any special considerations about serial(UART)
or kernel configurations ?
Is it need to modify blob ?
Could someone give me a help...?
Thank you.
ByungGi Baek.
==================================================
[EMAIL PROTECTED]
==================================================
No. 1 �츮 ���ͳ�, Daum
��� ���� ���� E-mail �ּ� �Ѹ��ϳ�
������ �ѱ� �˻����� Daum FIREBALL
http://www.daum.net
unsubscribe: body of `unsubscribe linux-arm' to [EMAIL PROTECTED]
++ Please use [EMAIL PROTECTED] for ++
++ kernel-related discussions. ++
