Hermann, nice work, and thanks. Runs fine here on Gentoo 64bit. Alex.
On Wed, Dec 23, 2009 at 3:01 PM, hermann <[email protected]> wrote: > Hi all > > I would announce the release of Jc_Gui. > It's a little host wrapped around the fantastic convolution engine from > Fons Adriaensen called jconvolver (zita-convolver) > > What is it for ? > > It's designed to search/load and run IR-*.wav files on a local machine > with jconvolver. It include a settings widget, were gain, delay, min/max > mem and mode can set and the used wave file and a part of it > (offset/length) could choosed. > As default, the min mem is set to your jack frame rate, the max mem is > set to the file length. > Those settings will saved in a config file, and used to start > jconvolver. Jc_Gui itself provide a Stereo Host, with master gain, tone > (bass,middle,high)controllers, balance slider, and for the output to > jconvolver per channel delay and gain controllers, and a wet/dry slider > to mix the output from jconvolver with the original source. > > So, you need only to connect Jc_Gui with your in/out put ports, (Jc_Gui > provide a port map there for), and can then load your IR files and start > stop jconvolver easy over the Gui. > The configurations can saved in presets, to reload them easy. > > What isn't it for ? > > It's a 2 Channel thing only, you can't make multi channel settings with > this jcgui. > > project page : http://jcgui.sourceforge.net/ > download : https://sourceforge.net/projects/jcgui/ > > enjoy hermann > > _______________________________________________ > Linux-audio-dev mailing list > [email protected] > http://lists.linuxaudio.org/mailman/listinfo/linux-audio-dev > -- www.openoctave.org [email protected] [email protected] _______________________________________________ Linux-audio-dev mailing list [email protected] http://lists.linuxaudio.org/mailman/listinfo/linux-audio-dev
