On Mon, Mar 12, 2007 at 12:53:28AM +0300, Andrew Gaydenko wrote: > Will anybody find a minute ot two to explain me how does the plugin > work - I mean a user POV rather technical realization details.
(Assuming you mean my plugin from the MCP package) This is an emulation of an analog phase delay line phaser. "Input gain (dB)" Just what is says it is... "Sections", The number (1..30) of first-order allpass filters that form the delay line. The phase shift of each section is zero at LF and goes up to 180 degrees at HF. "Frequency", (in octaves) the frequency at which each filter section produces 90 degrees phase shift. The range is 12 octaves. Halfway is middle C. "LFO frequency (Hz)" Frequency of the LFO that modulates the "Frequency" parameter above (0.01 to 30 Hz). "LFO waveform". Sets the waveform of the LFO, from falling saw, over triangle, to rising saw. "Modulation gain", The amount of modulation by the LFO output. "Feedback gain". The gain (-1..1) of the feedback from the delay line output back to the input. "Output mix". The first half crossfades between the inverted delay output and the input, the second half between input and the normal delay output. Mid position is input, i.e. no effect. So if you set "Sections" to N, the phase shift in the delay line will vary between 0 at LF and N/2 cycles at HF. The "Frequency" setting will determine the shape of the phase curve and consequently the set of N/2 frequencies where the delay output is in antiphase with the input. Setting "Output mix" to +0.5 will produce nulls at these frequencies. Setting it to -0.5 will produce maxima at these frequencies. "Feedback" will modify the effect in complicated ways. Finally the LFO makes the set of frequencies move up and down, producing the phasing effect. -- FA Follie! Follie! Delirio vano รจ questo !
