> +static int bsg_transport_complete_rq(struct request *rq, struct sg_io_v4
> *hdr)
> +{
> + struct bsg_job *job = blk_mq_rq_to_pdu(rq);
> + int ret = 0;
> +
> + /*
> + * The assignments below don't make much sense, but are kept for
> + * bug by bug backwards compatibility:
> + */
> + hdr->device_status = job->result & 0xff;
> + hdr->transport_status = host_byte(job->result);
> + hdr->driver_status = driver_byte(job->result);
> + hdr->info = 0;
> + if (hdr->device_status || hdr->transport_status || hdr->driver_status)
> + hdr->info |= SG_INFO_CHECK;
> + hdr->response_len = 0;
> +
> + if (job->result < 0) {
> + /* we're only returning the result field in the reply */
> + job->reply_len = sizeof(u32);
> + ret = job->result;
> + }
> +
> + if (job->reply_len && hdr->response) {
> + int len = min(hdr->max_response_len, job->reply_len);
> +
> + if (copy_to_user(ptr64(hdr->response), job->reply, len))
> + ret = -EFAULT;
> + else
> + hdr->response_len = len;
> + }
> +
> + /* we assume all request payload was transferred, residual == 0 */
> + hdr->dout_resid = 0;
> +
> + if (rq->next_rq) {
> + unsigned int rsp_len = blk_rq_bytes(rq->next_rq);
> +
> + if (WARN_ON(job->reply_payload_rcv_len > rsp_len))
This gives my a lot of new Warnings when running my tests on zFCP, non
of which happen when I run on 4.13.
After browsing the source some, I figured this is because in comparison
to the old code, blk_rq_bytes() is now called after we finished the
blk-request already and blk_update_bidi_request()+blk_update_request()
was already called. This will update rq->__data_len, and thus the call
here to get rsp_len will get a wrong value. Thus the warnings, and the
following calculation is actually wrong.
I figure you can just replace this call for blk_rq_bytes() with
'job->reply_payload.payload_len'. Its essentially the same value, but
the later is not changed after the job is committed as far as I could see
in the source. Driver makes use of it, but only reading as far as I
could make out after browsing the code for a bit.
I did a quick test with that change in place and that seems to work fine
now. As far as my tests go, they behave as they did before.
Beste Grüße / Best regards,
- Benjamin Block
> + hdr->din_resid = 0;
> + else
> + hdr->din_resid = rsp_len - job->reply_payload_rcv_len;
> + } else {
> + hdr->din_resid = 0;
> + }
> +
> + return ret;
> +}
> +
--
Linux on z Systems Development / IBM Systems & Technology Group
IBM Deutschland Research & Development GmbH
Vorsitz. AufsR.: Martina Koederitz / Geschäftsführung: Dirk Wittkopp
Sitz der Gesellschaft: Böblingen / Registergericht: AmtsG Stuttgart, HRB 243294
