Ol� pessoal,
algu�m poderia me dar um help quanto a um problema que estou enfrentando no CL9.
O que acontece � que tenho instalado 512MB de RAM em um servidor e j� aconteceu uma 4
vezes da m�quina parar sem mais nem menos.
Se volto o servidor para 256MB, n�o h� mais problemas.
Problema de RAM? N�o, j� testei outras mem�rias nesta m�quina e coloquei as mem�rias
que a mesma tinha em outras m�quinas. Problema de RAM est� descartado.
Pelo dmesg, posso ver logo no in�cio da inicializa��o que temos a linha "511MB LOWMEM
available".
Tenho 512MB de RAM e 1024 de SWAP.
Realmente, n�o sei o que acontece. Quem puder me d� uma help, agradeceria.
Obrigado,
Tato
Abaixo, o dmesg:
Linux version 2.4.21-31301U90_6cl ([EMAIL PROTECTED]) (gcc version 3.2.2) #1 Seg Ago
18 18:22:13 BRT 2003
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000001fff0000 (usable)
BIOS-e820: 000000001fff0000 - 000000001fff3000 (ACPI NVS)
BIOS-e820: 000000001fff3000 - 0000000020000000 (ACPI data)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
511MB LOWMEM available.
On node 0 totalpages: 131056
zone(0): 4096 pages.
zone(1): 126960 pages.
zone(2): 0 pages.
Kernel command line: BOOT_IMAGE=linux-CL9 ro root=303
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Initializing CPU#0
Detected 1200.048 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 2392.06 BogoMIPS
Memory: 512296k/524224k available (949k kernel code, 9368k reserved, 916k data, 104k
init, 0k highmem, BadRAM enabled)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 64K (64 bytes/line)
CPU: After generic, caps: 0383fbff c1cbfbff 00000000 00000000
CPU: Common caps: 0383fbff c1cbfbff 00000000 00000000
CPU: AMD Duron(tm) processor stepping 01
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 1200.0327 MHz.
..... host bus clock speed is 200.0054 MHz.
cpu: 0, clocks: 2000054, slice: 1000027
CPU0<T0:2000048,T1:1000016,D:5,S:1000027,C:2000054>
mtrr: v1.40 (20010327) Richard Gooch ([EMAIL PROTECTED])
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb480, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Disabling VIA memory write queue (PCI ID 0305, rev 03): [55] 89 & 1f -> 09
PCI: Using IRQ router VIA [1106/0686] at 00:07.0
Applying VIA southbridge workaround.
PCI: Disabling Via external APIC routing
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
Starting kswapd
kinoded started
VFS: Diskquotas version dquot_6.5.1 initialized
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ
SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
FDC 0 is a post-1991 82077
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Cronyx Ltd, Synchronous PPP and CISCO HDLC (c) 1994
Linux port (c) 1998 Building Number Three Ltd & Jan "Yenya" Kasprzak.
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 65536)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 447k freed
VFS: Mounted root (minix filesystem).
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:pio, hdd:pio
hda: SAMSUNG SP4002H, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 78242976 sectors (40060 MB) w/2048KiB Cache, CHS=77622/16/63
Partition check:
hda: [PTBL] [4870/255/63] hda1 hda2 hda3
Journalled Block Device driver loaded
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting. Commit interval 5 seconds
EXT3-fs: ide0(3,3): orphan cleanup on readonly fs
ext3_orphan_cleanup: deleting unreferenced inode 784908
EXT3-fs: ide0(3,3): 1 orphan inode deleted
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 104k freed
Real Time Clock Driver v1.10e
Adding Swap: 1052248k swap-space (priority -1)
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 18:37:26 Aug 18 2003
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 10 for device 00:07.2
PCI: Sharing IRQ 10 with 00:07.3
usb-uhci.c: USB UHCI at I/O 0xe400, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Found IRQ 10 for device 00:07.3
PCI: Sharing IRQ 10 with 00:07.2
usb-uhci.c: USB UHCI at I/O 0xe800, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal
spurious 8259A interrupt: IRQ7.
Linux video capture interface: v1.00
LVM version 1.0.5+(22/07/2002) module loaded
usb.c: registered new driver 'W996[87]CF USB driver'
loop: loaded (max 8 devices)
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal
8139too Fast Ethernet driver 0.9.26
PCI: Found IRQ 11 for device 00:09.0
eth0: RealTek RTL8139 Fast Ethernet at 0xe0927000, 00:e0:7d:cb:ed:d7, IRQ 11
eth0: Identified 8139 chip type 'RTL-8139C'
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.
---------------------------------------------------------------------------
Esta lista � patrocinada pela Conectiva S.A. Visite http://www.conectiva.com.br
Arquivo: http://bazar2.conectiva.com.br/mailman/listinfo/linux-br
Regras de utiliza��o da lista: http://linux-br.conectiva.com.br
FAQ: http://www.zago.eti.br/menu.html
