Juan Alberto Cirez posted on Fri, 22 Apr 2016 14:36:44 -0600 as excerpted: > Good morning, > I am new to this list and to btrfs in general. I have a quick question: > Can I add a new device to the pool while the btrfs filesystem balance > command is running on the drive pool?
Adding a device while balancing shouldn't be a problem. However, depending on your redundancy mode, you may wish to cancel the balance and start a new one after the device add, so the balance will take account of it as well and balance it into the mix. Note that while device add doesn't do more than that on its own, device delete/remove effectively initiates its own balance, moving the chunks on the device being removed to the other devices. So you wouldn't want to be running a balance and then do a device remove at the same time. Similarly with btrfs replace, altho in that case, it's more directly moving data from the device being replaced (if it's still there, or using redundancy or parity to recover it if not) to the replacement device, a more limited and often faster operation. But you probably still don't want to do a balance at the same time as it places unnecessary stress on both the filesystem and the hardware, and even if the filesystem and devices handle the stress fine, the result is going to be that both operations take longer as they're both intensive operations that will interfere with each other to some extent. Similarly with btrfs scrub. The operations are logically different enough that they shouldn't really interfere with each other logically, but they're both hardware intensive operations that will put unnecessary stress on the system if you're doing more than one at a time, and will result in both going slower than they normally would. And again with snapshotting operations. Making a snapshot is normally nearly instantaneous, but there's a scaling issue if you have too many per filesystem (try to keep it under 2000 snapshots per filesystem total, if possible, and definitely keep it under 10K or some operations will slow down substantially), and deleting snapshots is more work, so while you should ordinarily automatically thin down snapshots if you're automatically making them quite frequently (say daily or more frequently), you may want to put the snapshot deletion, at least, on hold while you scrub or balance or device delete or replace. Meanwhile, you mentioned being new to btrfs. If you haven't discovered the wiki yet, please spend some time reading the user documentation there, as it's likely to clear up a lot of questions you may have, and you'll better understand how to effectively work with the filesystem when you're done. It's well worth the time invested! =:^) https://btrfs.wiki.kernel.org -- Duncan - List replies preferred. No HTML msgs. "Every nonfree program has a lord, a master -- and if you use the program, he is your master." Richard Stallman -- To unsubscribe from this list: send the line "unsubscribe linux-btrfs" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
