--- Ursprüngliche Nachricht ---
Von: Andrea Gelmini <andrea.gelm...@gmail.com>
Datum: 08.01.2021 09:16:26
An: cedric.dew...@eclipso.eu
Betreff: Re: Raid1 of a slow hdd and a fast(er) SSD, howto to prioritize the
SSD?
Il giorno mar 5 gen 2021 alle ore 07:44 <cedric.dew...@eclipso.eu>
ha scritto:
>
> Is there a way to tell btrfs to leave the slow hdd alone, and to prioritize
the SSD?
You can use mdadm to do this (I'm using this feature since years in
setup where I have to fallback on USB disks for any reason).
>From manpage:
-W, --write-mostly
subsequent devices listed in a --build, --create, or
--add command will be flagged as 'write-mostly'. This is valid for
RAID1 only and means that the 'md' driver will avoid
reading from these devices if at all possible. This can be useful if
mirroring over a slow link.
--write-behind=
Specify that write-behind mode should be enabled
(valid for RAID1 only). If an argument is specified, it will set the
maximum number of outstanding writes allowed. The
default value is 256. A write-intent bitmap is required in order
to
use write-behind mode, and write-behind is only
attempted on drives marked as write-mostly.
So you can do this:
(be carefull, this wipe your data)
mdadm --create --verbose --assume-clean /dev/md0 --level=1
--raid-devices=2 /dev/sda1 --write-mostly /dev/sdb1
Then you use BTRFS on top of /dev/md0, after mkfs.btrfs, of course.
Ciao,
Gelma
Thanks Gelma.
What happens when I poison one of the drives in the mdadm array using this
command? Will all data come out OK?
dd if=/dev/urandom of=/dev/dev/sdb1 bs=1M count = 100?
When I do this test on a plain btrfs raid 1 with 2 drives, all the data comes
out OK (while generating a lot of messages about correcting data in dmesg -w)
Cheers,
Cedric
---
Take your mailboxes with you. Free, fast and secure Mail & Cloud:
https://www.eclipso.eu - Time to change!
