Hi All,
Need help on resolving a issue related to implementing High Availability at network level . I understand that this is not the right forum to ask this question , but since it is related to HA and Linux , I am asking here and I feel somebody here will have answer to the issues I am facing . I am trying to implement Ethernet Bonding , Both the interface in my server are connected to two different network switches . My configuration is as follows: ======== # cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) Bonding Mode: adaptive load balancing Primary Slave: None Currently Active Slave: eth0 MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: e4:e1:5b:d0:11:10 Slave queue ID: 0 Slave Interface: eth1 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: e4:e1:5b:d0:11:14 Slave queue ID: 0 ------------ # cat /sys/class/net/bond0/bonding/mode balance-alb 6 # cat /sys/class/net/bond0/bonding/miimon 0 ============ The issue for me is that I am seeing packet loss after configuring bonding . Tried connecting both the interface to the same switch , but still seeing the packet loss . Also , tried changing miimon value to 100 , but still seeing the packet loss. What I am missing in the configuration ? Any help will be highly appreciated in resolving the problem . Thanks Zaman -- Linux-cluster mailing list Linux-cluster@redhat.com https://www.redhat.com/mailman/listinfo/linux-cluster
