Hi All
I have a k65Flex ISA internal modem ( P-n-P ).
the "pnpdump" utility sees the card . The generated
configuration file I get is attached below, so that the card is seen
but when I try to use the "isapnp" uility I get the following error
Error Results of "isapnp k56flex.conf"
Board 1 has Identity 30 ff ff ff ff 37 42 63 0e:
CSC4237 Serial No 4294967295 [checksum 30]
Board 2 has Identity 49 ff ff ff ff 80 38 74 40:
PCT3880 Serial No 4294967295 [checksum 49]
Board @QN1c01/-1 not found
Error occured executing request 'CONFIGURE @QN1c01/-1
on or around line 261 further action aborted.
Has any tried a k65flex internal modem b4 on linux 2.0.33
Please forward me any pointers.
Thanks in Advance
Jeelani
Results of "pnpdump > k56flex.conf"
# Card 2: (serial identifier 92 ff ff ff ff 01 1c 2e 02)
# @QN1c01 Serial No -1 [checksum 92]
# Ident byte 16, (00) differs from resource data (40)
# Assuming the card is broken and this is the start of the resource data
# Logical device decodes 10 bit IO address lines
# Minimum IO base address 0x0000
# Maximum IO base address 0x0000
# IO base alignment 0 bytes
# Number of IO addresses required: 0
# (IO 0 (BASE 0x0000))
# Vendor defined tag: 74 38 80 ff ff
# Unknown tag ff ...
# Fixed IO base address 0x000a
# Number of IO addresses required: 0
# (IO 1 (BASE 0x000a))
#
# Logical device id @@@0000
#
# Edit the entries below to uncomment out the configuration required.
# Note that only the first value of any range is given, this may be changed if required
# Don't forget to uncomment the activate (ACT Y) when happy
(CONFIGURE @QN1c01/-1 (LD 0
# Unknown tag 00 ...
# ANSI string -->PC-TEL HSP K56FLEX PNP D/F/V MODEM<--
(IO 0 (BASE 0x02f8))
(INT 0 (IRQ 3 (MODE +E)))
(ACT Y)
))
-
To unsubscribe from this list: send the line "unsubscribe linux-diald" in
the body of a message to [EMAIL PROTECTED]
