On Fri 12 Jan 17:05 PST 2018, Karthikeyan Ramasubramanian wrote:
> Add device tree binding support for GENI based UART Controller in the
> QUP Wrapper.
>
> Signed-off-by: Karthikeyan Ramasubramanian <[email protected]>
> Signed-off-by: Girish Mahadevan <[email protected]>
> ---
> .../devicetree/bindings/serial/qcom,geni-uart.txt | 29
> ++++++++++++++++++++++
> .../devicetree/bindings/soc/qcom/qcom,geni-se.txt | 13 ++++++++++
> 2 files changed, 42 insertions(+)
> create mode 100644
> Documentation/devicetree/bindings/serial/qcom,geni-uart.txt
>
> diff --git a/Documentation/devicetree/bindings/serial/qcom,geni-uart.txt
> b/Documentation/devicetree/bindings/serial/qcom,geni-uart.txt
> new file mode 100644
> index 0000000..e7b9e24
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/serial/qcom,geni-uart.txt
> @@ -0,0 +1,29 @@
> +Qualcomm Technologies Inc. GENI Serial Engine based UART Controller
> +
> +The Generic Interface (GENI) Serial Engine based UART controller supports
> +console use-cases and is supported only by GENI based Qualcomm Universal
> +Peripheral (QUP) cores.
> +
> +Required properties:
> +- compatible: should contain "qcom,geni-debug-uart".
Why is this uart a _debug_ uart? Is there a separate binding for the
geni-uart?
I like that your naming here matches my suggestion with qcom,geni-i2c.
> +- reg: Should contain UART register location and length.
> +- reg-names: Should contain "se-phys".
No need to specify reg-names for a single reg.
> +- interrupts: Should contain UART core interrupts.
> +- clock-names: Should contain "se-clk".
Omit the "clk"
> +- clocks: clocks needed for UART, includes the core clock.
Be more specific.
> +- pinctrl-names/pinctrl-0/1: The GPIOs assigned to this core. The names
> + Should be "active" and "sleep" for the pin confuguration when core is
> active
> + or when entering sleep state.
Omit pinctrl information.
> +
> +Example:
> +uart0: qcom,serial@a88000 {
Don't use qcom, in node name. This should be named "serial".
> + compatible = "qcom,geni-debug-uart";
> + reg = <0xa88000 0x7000>;
> + reg-names = "se-phys";
> + interrupts = <0 355 0>;
<GIC_SPI 355 IRQ_TYPE_LEVEL_HIGH>
> + clock-names = "se-clk";
> + clocks = <&clock_gcc GCC_QUPV3_WRAP0_S0_CLK>;
> + pinctrl-names = "default", "sleep";
> + pinctrl-0 = <&qup_1_uart_3_active>;
> + pinctrl-1 = <&qup_1_uart_3_sleep>;
> +};
Regards,
Bjorn
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
