Martin Hoffmann wrote:
>
> Hello all,
>
> first i want to report a "bug" regarding cutting in vdr 0.83.
> When using the 7 and / or 9 keys to steer to a set mark the vdr process takes almost
>all the cpu time :-( - although the mark has been reached and olnly one picture is
>shown.
> So pressing 2, to start the cutting process takes longer than it should be, unless
>you leave the "playback" process...
Could this be a problem with DMA not being enabled for your harddisk?
> Second i wanted to ask if it would be possible to implement some kind of signal
>(audio or osd), that tells the user, if a command via remote control was understood !
> So the problem is the following : When cutting it sometimes happenes that the "0"
>for the cutting mark just isn't recognized , although i have pressed the button and
>it's annoying to find out at the end of the cutting process that one mark is missing
>:-(
> So a small audio "beep" or a OSD "MARK" or something would be nice!
If you enable the progress display (by pressing 'Ok' during replay)
you'll get all editing marks displayed and can immediately check
whether your new mark has been accepted.
Klaus
--
_______________________________________________________________
Klaus Schmidinger Phone: +49-8635-6989-10
CadSoft Computer GmbH Fax: +49-8635-6989-40
Hofmark 2 Email: [EMAIL PROTECTED]
D-84568 Pleiskirchen, Germany URL: www.cadsoft.de
_______________________________________________________________
--
Info:
To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as
subject.
