Hello, Please forgive me when I post this question a second time, but I think I read you were on vacation (hope you enjoyed it) and I didn't address this question to you.
I installed a second DVB-s card, which I bought as an DATA-only card and added the missing RAM as explained some time ago here by Thomas Mungai (http://linuxtv.org/mailinglists/linux-dvb/2001/05-2001/msg00657.html) . But I was not very successfull in using it, because when I tried it (with VDR) I got once some seconds recorded (but never again :-(( ), before I got an "ARM crashed" message. I get this messages very often when vdr tries to tune a channel. I would like to see, if I can test the result of my soldering. So here's my question: Is there any chance to do some deeper testing of the card hardware? I would especcially like some code to test the ARMs SDRAM memory (e.g. writing a bit pattern and read it back from the SDRAM). Is there any chance? I hope, this are just some few lines of code I can insert (or maybe its allready there with an DEBUG=test_arms_memory ? ;-)) and no hard or impossible stuff to do. Thank you for any advice! Joerg -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
