hi list,
Joerg Riechardt wrote: > How to install the remote control at Rev.1.3. > 1. in lirc 0.6.5pre1 configure point 1 Driver there is already under point 4 TV Cards the > Hauppauge DVBs Card, > there is only ver 2.1 mentioned, but rev 1.3 works as well. > save + run, make, make install > 2. in DVB/driver/lirc/Makefile adapt path for lirc location > make > 3. lircd.conf has to be adapted, bits 13 -> 32, > code 000000000000yyxx -> 00000000800000xx, see http://www.uni-mainz.de/~martin/lircd.conf > 4. DVB/driver make insmod, insmod lirc_dev, insmod lirc_dvb, lircd > Even the original Hauppauge remote works! I suspected it not to work, because I get no > ircommands in syslog from it, and I don't understand, how it can work without producing them. > J�rg i start lircd and get this output: lircd(hauppauge) ready if i start vdr or irw, lircd quits: accepted new client on /dev/lircd could not get hardware features this device driver does not support the new LIRC interface make sure you use a current version of the driver caught signal Terminated Any hints? (Suse Linux 7.2, Lirc 0.6.4, 2xHauppauge DVB-S Rev. 2.1, DVB-driver 30112001, VDR 0.98...) Thanx, Jochen Vieten -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
