Hi all,
I'm new to this list and first I want to thank you for your efforts to
get these DVB-s cards working under Linux.
I'd like to ask if there's somebody out there who can give me a hint,
what I could try to resolve the problem I'll describe below.
I installed a Hauppauge WinTV DVB-s card onto my Asus P3B-F-based
Pentium-III 450MHz pc:
# cat /proc/pci
[...]
Bus 0, device 11, function 0:
Multimedia controller: Philips Semiconductors SAA7146 (rev 1).
IRQ 10.
Master Capable. Latency=32. Min Gnt=15.Max Lat=38.
Non-prefetchable 32 bit memory at 0xdf000000 [0xdf0001ff].
[...]
There are several other pci-cards installed (network, scsi, sound) but
I finally managed to reserve irq 10 for the DVB-s alone. My Linux box
is running Redhat 7.2, kernel 2.4.17. I compiled and installed dvb
driver 0.9.4. When running "make insmod" the modules get loaded without
problems - the only "warning" I get is:
[...]
insmod: videodev: no module by that name found
[...]
(I think this should be no problem because videodev is compiled into
the kernel.) I get a black screen on TV with the copyright notice.
I copied dvbrc.astra to ~/.dvbrc. Now if I run tuxzap and try to switch
channel, I get the following output on the console:
[...]
failure event
: Erfolg
[...]
But there's still only a black screen on my TV.
Do you have any idea what I can try to get this card working?
Thanks in advance!
-Stephan
--
Info:
To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as
subject.
