Rene Bartsch wrote:
----- Original Message -----
From: "Holger Waechtler" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Monday, November 18, 2002 2:22 PM
Subject: [linux-dvb] Re: Off topic - IR
Hi,
you can solder a simple IR receiver directly onto your card.
For 2.1 and newer cards you can solder a mini-RCA jack like this:
Base -- GND
Ring -- signal
Tip -- VCC
Does it also work for the RCA on the CI-interface-board for the rev 1.3
cards?
yes.
example pinout for TSOP 1136:
+---------+
| |-- signal
| |
| |-- VCC
| |-- GND
+---------+
For old cards (rev < 2.1) with J2 connector you solder the IR receiver
directly on these pins:
pin 2 - VCC
pin 9 - signal
pin 10 - GND
Can I also use a TSOP1138 for RC5?
depends on the frequency of your IR control.
Holger
--
Info:
To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
