Am Dienstag, 18. Februar 2003 14:33 schrieb Freddy A�mann: Hello Freddy I had similar Problems while changing my Case and the motherboard ,before I use a PII 350 without any problem,when i change my Card (Siemens DVB-C rev1.5 to my new System Celeron @ 1200Mhz on a Chaintech Board I got also heaviness blocks an a bad sound on TV while watching live broadcast, palying a old recording was now Problem for me
my solution was a new antenna cabel (RG 59 ) witch is now connected directly to the card you can use czap to see what's your signal strength, look at the signal to noise values status 1f | signal ffff | snr e7e7 | ber 00000c9e | unc 00000001 | FE_HAS_LOCK status 1f | signal ffff | snr e6e6 | ber 00000c9e | unc 00000001 | FE_HAS_LOCK before I build my own cable a had values arround c7c7 , on the old PC it was now problem with original cable Hope it help's Regards Oliver Lorei > Hallo, > > I have got a problem. I had put my Card in a new PC. After that the Card > have following behavior: After start vdr I have only blocks on TV. After a > while the blocks disappear and I get a good picture and sound without any > errors. But then, after a short while, the blocks come back and the sound > is only crackling. A new installation and the newest driver did not changed > the effect. On an VIA KT133A-Mainboard with Athlon CPU I have the same > Problem. For a test, I had put the Card in the old PC. The Block changes to > a good picture too, but it stays. Have anyone an idea? What is that, what > can I do? > > the NEW system: > Die Konfiguration: > - Fujitsu/Siemens Cabel v. 1.5 (i think) > - MSI-6368 with VIA PLE133 Chipsatz > - Celeron 1200 > - 256 MB RAM > - 120 GB Samsung HD > - SUSE 8.0 Kernel 2.4.18 > - VDR 1.1.20, dvb 08.12.02 > > the OLD system: > - the same dvb-card > - ASUS-T2P4 Mainboard > - AMD K6-300 > - 64 MB RAM > - SUSE 8.0 Kernel 2.4.18 > - VDR 1.1.20, dvb 08.12.02 > > Freddy -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
