Hi Niklas, thx for your answer. With szap -r -n 003 I get the same result, I already tried that before.
Benedikt On Wed, 26 Nov 2003 15:23:16 +0100 Niklas Peinecke <[EMAIL PROTECTED]> wrote: > Benedikt wrote: > > Hi folks, > > After searching in the list, I couldn't find a thread matching my problem, so I am > > going to ask you. > > I just bought a Hauppauge WinTV Nova-s Card with a budget saa7146 chip. > > And I use it in a system consisting of: > > Athlon Barton XP 2500+ Processor, > > Asus A7N8X-X Mainboard, > > NVIDIA Geforce FX 5200 from Asus > > Creative SoundBlaster Live! > > > > Because of the new Hardware I use the kernel 2.6.0-test9 on a debian system. > > In the kernel configuration I chose the kernel modules for v4l and dvb support. > > The dvb-utils and libs I downloaded with apt-get and after some tests I could load > > the dvb modules and run szab. According to some sites and to szap the card uses > > the devices in /dev/dvb/adapter0/. > > And here my problem begins. When I start szap with szap -n channelnumber, I get an > > output which seems to be ok: > > szap -n 003 > > reading channels from file '/home/blackmessage/.szap/channels.conf' > > zapping to '3sat': > > sat 0, frequency = 11954 MHz H, symbolrate 27500000, vpid = 0x00d2, apid = 0x00dc > > using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' > > status 1f | signal aa19 | snr c68d | ber 00007000 | unc 00000000 | FE_HAS_LOCK > > status 1f | signal ab3b | snr c6bd | ber 00000000 | unc 00000000 | FE_HAS_LOCK > > > > So far, so good. But now when I try to start tvtime pointing to the device > > /dev/dvb/adapter0/dvr0 I get no picture. The same result I get with mplayer - < > > /dev/dvb/adapter0/dvr0 (mplayer message is: "... Playing - Reading from stdin..." > > Then it hangs) > > I also tried xawtv which crashes with a seg fault and xine, which brings a similar > > result as mplayer. > > If I am right /dev/video0 isn't the right device for dvb-s cards, if I it should > > run, it doesn't. > > > > In conclusion it seems to me that the dvb card is working and able to play but I > > can't play any channels with a play back application. > > I hope anybody can tell me what else I can do... > > > > Try > > szap -r -n 003 > > instead. > > Niklas > -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
