After running with the new firmware and current hg drivers for about
18 hours, I've got a USB disconnect. Below are excerpts from my log;
Aug 1 18:14:13 htpc2 kernel: MT2060: Spurs after : f_lo1: 1811000
f_lo2: 1196700 (kHz)
Aug 1 18:14:13 htpc2 kernel: MT2060: IF1: 1229MHz
Aug 1 18:14:13 htpc2 kernel: MT2060: PLL freq=578166kHz
f_lo1=1811000kHz f_lo2=1196700kHz
Aug 1 18:14:13 htpc2 kernel: MT2060: PLL div1=113 num1=12 div2=74
num2=6502
Aug 1 18:14:13 htpc2 kernel: MT2060: PLL [1..5]: 43 71 6 96 95
Aug 1 18:14:13 htpc2 kernel: MT2060: IF1: 1204MHz
Aug 1 18:14:13 htpc2 kernel: MT2060: PLL freq=482000kHz
f_lo1=1686000kHz f_lo2=1167850kHz
Aug 1 18:14:13 htpc2 kernel: MT2060: PLL div1=105 num1=24 div2=72
num2=8115
Aug 1 18:14:13 htpc2 kernel: MT2060: PLL [1..5]: 56 69 3 fb 91
Aug 1 18:14:14 htpc2 kernel: MT2060: IF1: 1229MHz
Aug 1 18:14:14 htpc2 kernel: MT2060: PLL freq=506000kHz
f_lo1=1735000kHz f_lo2=1192850kHz
Aug 1 18:14:14 htpc2 kernel: MT2060: PLL div1=108 num1=28 div2=74
num2=4531
Aug 1 18:14:14 htpc2 kernel: MT2060: PLL [1..5]: 57 6c 3 1b 95
Aug 1 18:14:14 htpc2 kernel: modifying (0) streaming state for 0
Aug 1 18:14:14 htpc2 kernel: data for streaming: 0 10
Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1
Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 12
Aug 1 18:14:15 htpc2 kernel: modifying (0) streaming state for 1
Aug 1 18:14:15 htpc2 kernel: data for streaming: 0 10
Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1
Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 12
Aug 1 18:14:15 htpc2 kernel: modifying (0) streaming state for 1
Aug 1 18:14:15 htpc2 kernel: data for streaming: 0 10
Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1
Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 12
Aug 1 18:14:15 htpc2 kernel: usb 6-1: USB disconnect, address 6
Aug 1 18:14:15 htpc2 kernel: mt2060 I2C write failed
Aug 1 18:14:15 htpc2 kernel: dvb-usb: could not submit URB no. 0 -
get them all back
Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 0
Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 13
Aug 1 18:14:15 htpc2 kernel: dvb-usb: error while enabling fifo.
Aug 1 18:14:15 htpc2 vdr: [23167] ERROR: can't set filter (pid=18,
tid=4E, mask=FE): No such device
Aug 1 18:14:15 htpc2 kernel: ep 0 read error (status = -19)
Aug 1 18:14:15 htpc2 kernel: I2C read failed on address b
Aug 1 18:14:15 htpc2 kernel: ep 0 read error (status = -19)
Aug 1 18:14:15 htpc2 kernel: I2C read failed on address b
Aug 1 18:14:15 htpc2 kernel: ep 0 read error (status = -19)
Aug 1 18:14:15 htpc2 kernel: I2C read failed on address b
Aug 1 18:14:16 htpc2 kernel: ep 0 read error (status = -19)
Aug 1 18:14:16 htpc2 kernel: I2C read failed on address b
Aug 1 18:14:16 htpc2 vdr: [23168] frontend 3 lost lock on channel 1,
tp 506
Aug 1 18:14:16 htpc2 kernel: ep 0 read error (status = -19)
Aug 1 18:14:16 htpc2 kernel: I2C read failed on address b
Aug 1 18:14:16 htpc2 vdr: [23168] frontend 3 regained lock on
channel 1, tp 506
Aug 1 18:14:17 htpc2 kernel: ep 0 read error (status = -19)
when loading the firrmware;
Aug 1 00:01:16 htpc2 kernel: dib0700: loaded with support for 3
different device-types
Aug 1 00:01:16 htpc2 kernel: FW GET_VERSION length: -32
Aug 1 00:01:16 htpc2 kernel: cold: 1
Aug 1 00:01:16 htpc2 kernel: dvb-usb: found a 'Hauppauge Nova-T 500
Dual DVB-T' in cold state, will try to load a firmware
Aug 1 00:01:16 htpc2 kernel: b2c2-flexcop: found the stv0299 at i2c
address: 0x68
Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 0 (ST STV0299
DVB-S)...
Aug 1 00:01:16 htpc2 kernel: b2c2-flexcop: initialization of 'Sky2PC/
SkyStar 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
Aug 1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:08.0[A] ->
GSI 19 (level, low) -> IRQ 18
Aug 1 00:01:16 htpc2 kernel: CORE cx88[0]: subsystem: 0070:9002,
board: Hauppauge Nova-T DVB-T [card=18,autodetected]
Aug 1 00:01:16 htpc2 kernel: TV tuner 4 at 0x1fe, Radio tuner -1 at
0x1fe
Aug 1 00:01:16 htpc2 kernel: dvb-usb: downloading firmware from file
'dvb-usb-dib0700-01.fw'
Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: Hauppauge model 90002,
rev C176, serial# 47706
Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: MAC address is 00-0D-
FE-00-BA-5A
Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: tuner model is
Thompson DTT7592 (idx 76, type 4)
Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: TV standards ATSC/DVB
Digital (eeprom 0x80)
Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: audio processor is
None (idx 0)
Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: decoder processor is
CX882 (idx 25)
Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: has no radio, has IR
receiver, has no IR transmitter
Aug 1 00:01:16 htpc2 kernel: cx88[0]: hauppauge eeprom: model=90002
Aug 1 00:01:16 htpc2 kernel: input: cx88 IR (Hauppauge Nova-T DVB-T
as /class/input/input3
Aug 1 00:01:16 htpc2 kernel: cx88[0]/0: found at 0000:00:08.0, rev:
5, irq: 18, latency: 32, mmio: 0xea000000
Aug 1 00:01:16 htpc2 kernel: cx88[0]/0: registered device video0 [v4l2]
Aug 1 00:01:16 htpc2 kernel: cx88[0]/0: registered device vbi0
Aug 1 00:01:16 htpc2 kernel: cx88[0]/2: cx2388x 8802 Driver Manager
Aug 1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:08.2[A] ->
GSI 19 (level, low) -> IRQ 18
Aug 1 00:01:16 htpc2 kernel: cx88[0]/2: found at 0000:00:08.2, rev:
5, irq: 18, latency: 32, mmio: 0xeb000000
Aug 1 00:01:16 htpc2 kernel: dib0700: firmware started successfully.
Aug 1 00:01:16 htpc2 kernel: cx2388x dvb driver version 0.0.6 loaded
Aug 1 00:01:16 htpc2 kernel: cx8802_register_driver() ->registering
driver type=dvb access=shared
Aug 1 00:01:16 htpc2 kernel: CORE cx88[0]: subsystem: 0070:9002,
board: Hauppauge Nova-T DVB-T [card=18]
Aug 1 00:01:16 htpc2 kernel: cx88[0]/2: cx2388x based dvb card
Aug 1 00:01:16 htpc2 kernel: DVB: registering new adapter (cx88[0])
Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 1 (Conexant
CX22702 DVB-T)...
Aug 1 00:01:16 htpc2 kernel: dvb-usb: found a 'Hauppauge Nova-T 500
Dual DVB-T' in warm state.
Aug 1 00:01:16 htpc2 kernel: dvb-usb: will pass the complete MPEG2
transport stream to the software demuxer.
Aug 1 00:01:16 htpc2 kernel: DVB: registering new adapter (Hauppauge
Nova-T 500 Dual DVB-T)
Aug 1 00:01:16 htpc2 kernel: I2C read failed on address b
Aug 1 00:01:16 htpc2 kernel: I2C read failed on address a
Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 2 (DiBcom
3000MC/P)...
Aug 1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:11.5[C] ->
Link [ALKC] -> GSI 22 (level, low) -> IRQ 22
Aug 1 00:01:16 htpc2 kernel: PCI: Setting latency timer of device
0000:00:11.5 to 64
Aug 1 00:01:16 htpc2 kernel: MT2060: successfully identified (IF1 =
1204)
Aug 1 00:01:16 htpc2 kernel: MT2060: calibration was successful: 125
Aug 1 00:01:16 htpc2 kernel: dvb-usb: will pass the complete MPEG2
transport stream to the software demuxer.
Aug 1 00:01:16 htpc2 kernel: DVB: registering new adapter (Hauppauge
Nova-T 500 Dual DVB-T)
Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 3 (DiBcom
3000MC/P)...
Aug 1 00:01:16 htpc2 kernel: MT2060: successfully identified (IF1 =
1229)
Aug 1 00:01:16 htpc2 kernel: MT2060: calibration was successful: 135
Aug 1 00:01:16 htpc2 kernel: dvb-usb: Hauppauge Nova-T 500 Dual DVB-
T successfully initialized and connected.
Aug 1 00:01:16 htpc2 kernel: usbcore: registered new interface
driver dvb_usb_dib0700
--
Torgeir Veimo
[EMAIL PROTECTED]
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
