You need both antenna connectors connected if you intend to use both tuners (dual tuner mode). Tuner 0 seems to be the side connector and tuner 1 the top connector.
/Henrik On Dec 14, 2007 8:49 AM, Nicolas Will <[EMAIL PROTECTED]> wrote: > > On Thu, 2007-12-13 at 23:24 +0100, Luca wrote: > > Well... the device seem working properly after I put the firmware in > > /lib/firmware... maybe before I was using the wrong one... mah! Now > > dib0700 module say me that loads the firmware at ... (really two > > different firmwares, 1.10 and 03-pre). > > > As the wiki page says, you need to either: > > rename the 1.10 firmware file to the 03-pre name > symlink 1.10 to 03-pre > > You are not using the 03-pre at all, but you need the name as the code > did not change the hard-coded file name. > > As with every firmware change, you need to cold boot the device, by > either unplugging the stick, or by *shutting off* (not just a reboot) > the machine. > > > > > I don't know if it can work with both antennas... I'm playing with > > them, > > because I think it's an antenna problems... > > The diversity feature (2 antennas) is certainly *not* supported at this > time. > > > > > > Kaffein is awesome! But sadly I cannot find any channel... sigh... > > > Make sure you are using the right firmware. > > Nico > > > _______________________________________________ > linux-dvb mailing list > linux-dvb@linuxtv.org > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb >
_______________________________________________ linux-dvb mailing list linux-dvb@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
