On Wed, Feb 27, 2008 at 11:34:58AM -0500, Steven Toth wrote:
> Andy Wettstein wrote:
>> Hi,
>>
>> I just installed a hauppauge hvr1250 and it seems to be ok, but
>> there are ton of messages being logged.  I am wondering if these  
>> messages are something to be concerned about.
>>
>> uname:
>> Linux beerme 2.6.24-1-686 #1 SMP Mon Feb 11 14:37:45 UTC 2008 i686 GNU/Linux
>>
>>
>> Relevant dmesg output:
>>
>> cx23885 driver version 0.0.1 loaded
>> ACPI: PCI Interrupt Link [APC5] enabled at IRQ 16
>> ACPI: PCI Interrupt 0000:01:00.0[A] -> Link [APC5] -> GSI 16 (level, low) -> 
>> IRQ 19
>> CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 
>> [card=3,autodetected]
>> cx23885[0]: i2c bus 0 registered
>> cx23885[0]: i2c bus 1 registered
>> cx23885[0]: i2c bus 2 registered
>> tveeprom 0-0050: Encountered bad packet header [ff]. Corrupt or not a 
>> Hauppauge eeprom.
>> cx23885[0]: warning: unknown hauppauge model #0
>> cx23885[0]: hauppauge eeprom: model=0
>> cx23885[0]: cx23885 based dvb card
>> MT2131: successfully identified at address 0x61
>> DVB: registering new adapter (cx23885[0])
>> DVB: registering frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)...
>> cx23885[0]/0: found at 0000:01:00.0, rev: 2, irq: 19, latency: 0, mmio: 
>> 0xfd800000
>> PCI: Setting latency timer of device 0000:01:00.0 to 64
>
> The driver was loaded with debug enabled.

Thanks.  Much quieter with the debugging off.  Now to figure out why 
mythbackend segfaults recording from this card.

_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

Reply via email to