The board, as shipped from RPCG, comes with their "Utility" program in
flash. So, if you power up with the terminal parameters 9600n81 and no
flow control, you should see the monitor prompt.
Are you connected to the monitor port (labeled MON) and not the Ethernet
port (they're the same connector, unfortunately).
Good luck!
Tim.
"Steven J. Hill" wrote:
> Greetings.
>
> Well, I searched the archives and found nothing. I have a RPX Lite
> board and have verified the jumper settings and have the serial cable
> that they supplied. Unfortunately I cannot seem to get anything over
> the link using 'minicom' under Linux. Has anyone connected to this
> board using a dumb terminal emulator under Linux? Thanks in advance.
>
> -Steve
--
M. Tim Jones - Core Platform Lead
Mobile Networking Technologies
CellPort Labs Inc. <http://www.cellport.com>
4888 East Pearl Circle Boulder, CO 80301
(303) 541-0722 (voice) (303) 541-0731 (fax) (303) 517-3392 (mob)
--
To unsubscribe from this list, send a message to [EMAIL PROTECTED]
with the command "unsubscribe linux-embedded" in the message body.
For more information, see <http://waste.org/mail/linux-embedded>.
