Petter Andersson schrieb:
> Hi all,
> My board has a 80386 CPU, 2MB flash, 16MB ram, two
Looks good: RAM ok, Flash a little bit small but should work
>
> serial RS232 ports, and a 82380 (for interrupt
> controlling, DMA, ...), plus additional
> special-purpose units added on.
Non standard ? You has write your own access code perhaps.
>
> I just wanna know if I could use linux to boot this
> board with. I don't have something called BIOS. Which
> way do you recommend? Writing a code to initialize
> devices (what BIOS does), or redesign the board to
> have a BIOS on it.
Mainly you don't need any BIOS for initializations or normal work of
Linux. Linux do it for you if it known about. But what is happen on
system boot up ? Now, in most cases you need a BIOS too boot Linux. If
there is now BIOS you have to look for some other solutions to boot up
Linux. Ask further.
>
>
> --Petter
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Auctions - buy the things you want at great prices
> http://auctions.yahoo.com/
--
======================================================================
Stephan Linz
Software Engineer
MAZeT GmbH Email: mailto:[EMAIL PROTECTED]
Branche office Jena Phone: +49-3641-2809-55
Göschwitzer Straße 32 Fax : +49-3641-2809-12
D-07745 JENA
Germany
Visit our web-pages: http://www.MAZeT.de
======================================================================
--
To unsubscribe from this list, send a message to [EMAIL PROTECTED]
with the command "unsubscribe linux-embedded" in the message body.
For more information, see <http://waste.org/mail/linux-embedded>.
