Hi, just noticed this message from IPaddr2, it seems to be using a
wrong sintaxis:
IPaddr2[8310]: 2007/08/04_07:47:54 INFO: /sbin/ip -f inet addr add
10.129.4.236/22 brd 10.129.7.255 dev eth0
IPaddr2[8310]: 2007/08/04_07:47:54 INFO: /sbin/ip link set eth0 up
IPaddr2[8310]: 2007/08/04_07:47:54 INFO:
/usr/lib64/heartbeat/send_arp -i 200 -r 5 -p
/var/run/heartbeat/rsctmp/send_arp/send_arp-10.129.4.236 eth0
10.129.4.236 10.129.4.236 ffffffffffff
crmd[6835]: 2007/08/04_07:47:54 info: process_lrm_event: LRM operation
ip-principal_start_0 (call=43, rc=0) complete
crmd[6835]: 2007/08/04_07:47:54 info: build_operation_update: Digest
for 0:0;8:18:b0bebce2-a95d-4f56-a047-277dad898fc6
(ip-principal_start_0) was c56c83547e40f33434ad901cb1d2b2ba
crmd[6835]: 2007/08/04_07:47:54 info: log_data_element:
build_operation_update: digest:source <parameters ip="10.129.4.236"
cidr_netmask="22" nic="eth0"/>
tengine[10317]: 2007/08/04_07:47:54 info: match_graph_event: Action
ip-principal_start_0 (8) confirmed on asusis-ope2
tengine[10317]: 2007/08/04_07:47:54 info: send_rsc_command: Initiating
action 10: fs-hadata_start_0 on asusis-ope2
cib[8376]: 2007/08/04_07:47:54 info: write_cib_contents: Wrote version
0.43.912 of the CIB to disk (digest: 66a06eaeaaf46b52d855b64621e619f0)
lrmd[6832]: 2007/08/04_07:47:54 info: RA output:
(ip-principal:start:stderr) send_arp: sends out custom ARP packet.
usage: send_arp [-i repeatinterval-ms] [-r repeatcount] [-p pidfile] \
device src_ip_addr src_hw_addr broadcast_ip_addr netmask
where:
repeatinterval-ms: timing, in milliseconds of sending arp packets
For each ARP announcement requested, a pair of ARP packets is sent,
an ARP request, and an ARP reply. This is becuse some systems
ignore one or the other, and this combination gives the greatest
chance of success.
Each time an ARP is sent, if another ARP will be sent then
the code sleeps for half of repeatinterval-ms.
repeatcount: how many pairs of ARP packets to send.
See above for why pairs are sent
pidfile: pid file to use
device: netowrk interace to use
src_ip_addr: source ip address
src_hw_addr: source hardware address.
If "auto" then the address of device
broadcast_ip_addr: ignored
netmask: ignored
IPaddr2[8310]: 2007/08/04_07:47:54 ERROR: Could not send gratuitous arps
Regards,
Ciro
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
