perhaps not. The only thing I could find was:
start:
* 1.IPv6addr will choice a proper interface for the new address.
* 2.Then assign the new address to the interface.
* 3.Wait until the new address is available (reply ICMPv6 ECHO
packet)
* 4.Send out the unsolicited advertisements.
Andrew Beekhof wrote:
On 10/12/07, Scott Machtmes <[EMAIL PROTECTED]> wrote:
I have heartbeat 2.08 on a 2 node active/passive cluster. It's working
fine. Now I'm trying to add an IPv6 address to managed and failed over
as well. I'd like the ipv6 addr to be on the eth0:0 where the ip public
address gets configured. I can't get that to happen. As a test on the
command line I'm doing:
/etc/ha.d/resource.d/IPv6addr fd00:60:69bc:50::101/64/eth0 start
The addr does start but ipv6addr is always putting the address on the
eth1 interface( which in my case is my private heartbeat network).
Any ideas?
is NIC one of the RA's parameters?
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
--
-------------------------------------
Scott Machtmes, Sr. Systems Administrator
Engineering Lab Services
Brocade
1745 Technology Drive
San Jose, Ca. 95110
408-333-7203
[EMAIL PROTECTED]
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
