Hi, I used the development edition(Heartbeat-Dev-0f41ec29aef5.tar.gz) and confirmed fail over.
When I tried the following cases, clone did not stop.
In addition, the fail over was not generated, too.
1)I start IPaddr resource and clone in two nodes
Node: rh44-1 (1b983d2a-c2eb-4dbd-a07b-061974558ace): online
Node: rh44-2 (fe50e16b-3592-4d85-9aec-5e32b08b2afd): online
Resource Group: test
resource_3 (heartbeat::ocf:IPaddr): Started rh44-1
Clone Set: clone1
resource_dummy:0 (heartbeat::ocf:Dummy): Started rh44-2
resource_dummy:1 (heartbeat::ocf:Dummy): Started rh44-1
2)It causes a monitor error in an IPaddr resource
3)IPaddr stopped, but does not do fail over.
In addition, clone is moving in an active node.
Node: rh44-1 (1b983d2a-c2eb-4dbd-a07b-061974558ace): online
Node: rh44-2 (fe50e16b-3592-4d85-9aec-5e32b08b2afd): online
Clone Set: clone1
resource_dummy:0 (heartbeat::ocf:Dummy): Started rh44-2
resource_dummy:1 (heartbeat::ocf:Dummy): Started rh44-1
IPaddr did fail over after having failed in a monitor in the former
version(ver2.1.2).
In addition, clone stopped in an active node.
Is there the setting to make behavior same as a former version?
I do not use stonith in a former version.
When I do not use stonith, will this be movement of the future version?
* Possibly there may be a person doing the same question.
Regards,
Hideo Yamauchi.
hb_report_dev_Fo.tar.gz
Description: 3995217667-hb_report_dev_Fo.tar.gz
_______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
