Hi, On Thu, Nov 15, 2007 at 03:29:58PM -0800, Jordan Mendler wrote: > I have been setting up LInux-HA for a web cluster, and ran into some > confusion when configuring systems with 2 network cards. Here is my setup in > a nutshell (note eth1 IP has been changed for security): > > WWW0: > eth0 --> 10.10.0.60 (static, internal IP) > eth1 --> 64.0.0.1 (linux-ha, public IP) > > WWW1: > eth0 --> 10.10.0.61 (static, internal IP) > eth1 --> 64.0.0.1 (linux-ha, public IP) > > WWW2: > eth0 --> 10.10.0.62 (static, internal IP) > eth1 --> 64.0.0.2 (linux-ha, public IP) > > I was able to get the three machines failing over to each other fine, when I > left eth1 unconfigured and had linux-HA work with eth0. Now that I am trying > to keep eth0 static and have linux-HA configure/failover eth1, I am stuck as > to how to get this working. I searched the mailing list and found something > about specifying network device, but could not figure out how to get that > working. If anyone can help me out with this I would greatly appreciate it. > > Thanks in advanced for the help, and thanks so much for maintaining this > great software.
Is this v1 or v2 style configuration? For v2, you should set the "nic" attribute of your IPaddr resources to wherever you want your virtual interface. For v1, it's IPaddr::ip-address[/netmask[/interface][/broadcast]] Or I didn't understand your question. Thanks, Dejan > Cordially, > Jordan > _______________________________________________ > Linux-HA mailing list > [email protected] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
