Hi,
I start the 8 IPs and then the application, which depends on the 8
addresses. So it's ordered...
Is there a way to group the IPs to allow the starting in parallel and
make an extra application group, which depends on the IP group?
Thanks for your help.
Regards.
Dejan Muhamedagic schrieb:
Hi,
On Tue, Apr 15, 2008 at 04:16:48PM +0200, Steinhauer Juergen wrote:
Hi,
my HA-applications uses 8 IPs, which leads to a total failover time of
11-13 seconds.
If they have to be ordered then probably there isn't much you can
do. Otherwise, they are going to be stopped/started in parallel.
What does you configuration look like?
Thanks,
Dejan
I found the alternative in the FAQs with the static loopback interfaces,
but that's not accurate for me. Both nodes have to communicate with each
other via the HA addresses. And this would not be possible with static
loopbacks.
Is there any other idea out there?
Regards.
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
