On Mon, Feb 9, 2009 at 11:36, Tobias Appel <[email protected]> wrote: > Hi, > > I've configured stonith/ssh on my 2-node cluster (Heartbeat 2.1.4). This > is still in testing since I haven't happen to find a good STONITH device > yet. > Anyway, I ran some tests this morning and pulled the cross-over cable. > After a few seconds one node rebooted the other one. It came back and > could not connect to the cluster so it rebooted the active one. Once > this came back on, it did the same thing again. Both nodes kept > rebooting each other over and over. > > Is this a configuration issue
Basically yes. For a 2-node cluster this is how it works, _unless_ you tell stonith to power off the nodes instead of restarting them or you don't start the cluster software when the node boots. But of course there are drawback to doing this too. > or is it working like intended? If it's > the latter one, how is it handled when using something like a > programmable PDU from APC? > > If it's a configuration issue, I will have a closer look at my > configuration and post it here or in IRC. > > Thanks in advance, > > Tobias > > _______________________________________________ > Linux-HA mailing list > [email protected] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems > _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
