Hi,
I observed below error message when I upgraded drbd to drbd-8.3.0 in
heartbeat 2.1.4 cluster on 2.6.18-8.el5xen.
crmd[4242]: 2009/03/16_06:38:17 info: do_lrm_rsc_op: Performing
op=resource_drbd:0_start_0 key=7:5:0:fbe18f1e-31f4-4272-b23a-2c106e4064b0)
lrmd[4239]: 2009/03/16_06:38:17 info: rsc:resource_drbd:0: start
lrmd[4239]: 2009/03/16_06:38:18 info: RA output:
(resource_drbd:0:start:stdout)
lrmd[4239]: 2009/03/16_06:38:20 info: RA output:
(resource_drbd:0:start:stdout)
drbd[4503]: 2009/03/16_06:38:20 ERROR: r0 start: not in Secondary mode
after start.
The debugging of OCF drbd RA showed that the reason for the error was
deprecated "drbdadm state $RESOURCE" command. Which was returning below
output
# drbdadm state r0
'drbdadm state' is deprecated, use 'drbdadm role' instead.
Primary/Unknown
Following small patch was able resolve this issue, can someone tell me
whether it is a correct method to resolve this issue. Because "drbdadm role
$RESOURCE" command may not work in previous versions of DRBD.
--- drbd.org 2009-03-17 01:39:22.000000000 -0400
+++ drbd.changed 2009-03-17 01:48:36.000000000 -0400
@@ -240,7 +240,7 @@ is_drbd_enabled () {
drbd_get_status() {
- DRBD_STATE=$(do_drbdadm state $RESOURCE)
+ DRBD_STATE=$(do_drbdadm role $RESOURCE)
DRBD_STATE_LOCAL=$(echo $DRBD_STATE | sed -e 's#/.*##')
DRBD_STATE_REMOTE=$(echo $DRBD_STATE | sed -e 's#.*/##')
DRBD_CSTATE=$(do_drbdadm cstate $RESOURCE)
Regards,
Arun.
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
