Hi Keisuke-san, On Tue, Jun 09, 2009 at 01:11:24PM +0900, Keisuke MORI wrote: > Hi, > > 2009/6/4 Rob Gallagher <[email protected]>: > > Running the resource manually gives: > > > > r...@charlene:/etc/ha.d# /etc/ha.d/resource.d/IPv6addr > > 2001:770:18:2:0:0:c101:db4a/128/eth0 start 2009/06/04_10:15:50 ERROR: > > Generic error ERROR: ?Generic error > > Didn't you get an error log something like this (in ha-log or syslog)? > I saw this in my reproduce test when I specify /128 prefix. > > Jun 9 12:49:15 pacifica IPv6addr: [8640]: ERROR: no valid mecahnisms > > It means that the RA could not find a proper network interface, > and it most likely be a configuration error. > > > However if I change the prefix to /64 it is added without error: > > If your network is setup as /64 prefix, then you should specify > /64 to the parameter of IPv6addr. > > By the way, specifying an interface (i.e. /eth0) is not supported yet > in IPv6addr. (would be ignored)
There was recently a patch for it sent to the list, to which I objected, IIRC, that it should accept a network interface as a parameter (as with IPaddr). The contributor didn't send any further patches. I'm right now rather overwhelmed with various obligations, so perhaps you could take a look. Cheers, Dejan > Hope it helps. > > Thanks, > > -- > Keisuke MORI > _______________________________________________ > Linux-HA mailing list > [email protected] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
