Hi Dejan, I had without doubt miss it because effectively your command works fine ...
PS :just for my knowledge : what's the meaning of the "-" at the end ? Thanks a lot Alain Dejan Muhamedagic a écrit : > Hi, > > On Wed, Mar 30, 2011 at 02:52:37PM +0200, Alain.Moulle wrote: > >> Hi, >> >> Sorry but I can't find any crm command to change after configuration >> a value in the "op" lines of a primitive, for example : >> a primitive with : >> op monitor interval="20" timeout="60" on-fail="restart" start-delay="60" \ >> I'd like to change by crm command for example start-delay value. >> (again, it is to be included in scripts, that's why I don't use crm >> configure edit) >> >> Did I miss the command or is there no way to do this ? >> > > No, there's no command for exactly this purpose. I think I've > already mentioned before that you can do sth like: > > # crm configure show ... | somescript | crm configure load update - > > In pacemaker 1.1.x there's crm configure filter command. > > Thanks, > > Dejan > > >> Thanks >> Alain >> _______________________________________________ >> Linux-HA mailing list >> [email protected] >> http://lists.linux-ha.org/mailman/listinfo/linux-ha >> See also: http://linux-ha.org/ReportingProblems >> > _______________________________________________ > Linux-HA mailing list > [email protected] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems > > > _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
