I am using drbd + xen + heartbeat. The CPU load is very low considering the
htop> On 11-05-12 03:53 PM,
[email protected] wrote:>>>> Hello!I'm using heartbeat
version 3.0.3-2 on debian squeeze with dedicated gigabit>> ethernet
interface for the heartbeat. But even this generates the following>>
message:WARN: Gmain_timeout_dispatch: Dispatch function for send local status
took>> too long to execute: 60 ms (> 50 ms) (GSource: 0x101c350)I'm using eth1
to eth2>> and to Synchronize DRBD(eth1) HEARBEAT (eth2).I tried increasing
the values>> deadtime = 20 and 15 warntimeInterface Gigabit Ethernet
controller: Intel>> Corporation 82575GB Serv.1 and the Ethernet controller:
Broadcom Corporation NetXtreme>> II BCM5709 in Serv.2Tested using two
Broadcom for the heartbeat, also without>> success.Thanks>>
_______________________________________________>> Linux-HA mailing list>>
[email protected]>>
http://lists.linux-ha.org/mailman/listinfo/linux-ha>> See also:
http://linux-ha.org/ReportingProblems>>>>> I had this
problem in a shared virtual environment. The problem was a> high load on the
CPU resources. What's the load like on this system?>
_______________________________________________> Linux-HA mailing list>
[email protected]>
http://lists.linux-ha.org/mailman/listinfo/linux-ha> See also:
http://linux-ha.org/ReportingProblems>
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
