Thank you very much!, very kind of you. I had to configure two resources to accomplish thehe same.
Regards 2012/5/22 Andreas Kurz <[email protected]> > On 05/22/2012 02:12 PM, Net Warrior wrote: > > Hi there > > Reading the documentantion I found that I can have various disk in the > > configuration, > > and I need to do so, this is my conf > > > > resource myresource { > > syncer { > > rate 100M; > > } > > volume 0 { > > device /dev/drbd1; > > disk /dev/rootvg/lvu02; > > meta-disk /dev/rootvg/drbdmetadata[0]; > > } > > > > volume 1 { > > device /dev/drbd2; > > disk /dev/rootvg/lvarch; > > meta-disk /dev/rootvg/drbdmetadata[0]; > > } > > > > on node1 { > > address x.x.x.x:7789; > > } > > on node2 { > > address x.x.x.x:7789; > > } > > > > } > > > > When creating the resource I get the following error > > drbd.d/myresource.res:7: Parse error: 'protocol | on | disk | net | > syncer > > | startup | handlers | ignore-on | stacked-on-top-of' expected, > > but got 'volume' (TK 281) > > this is a DRBD 8.4 feature > > > > > Im using this version > > drbd83-8.3.8-1.el4_8 > > ** > > > > Any help on this? > > Please read the DRBD users guide for version 8.3 and _not_ 8.4 ... > http://www.drbd.org/users-guide-8.3/ > > Regards, > Andreas > > -- > Need help with Pacemaker? > http://www.hastexo.com/now > > > Thanks you very much for your time and support > > Regards > > _______________________________________________ > > Linux-HA mailing list > > [email protected] > > http://lists.linux-ha.org/mailman/listinfo/linux-ha > > See also: http://linux-ha.org/ReportingProblems > > > > > > > _______________________________________________ > Linux-HA mailing list > [email protected] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems > _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
