On 04/07/2013, at 11:16 AM, Leland <[email protected]> wrote: > I'm setting up a 4-node cluster where 2 of the nodes will run an > active/active DRBD and the other two nodes will be available in case one of > the "active" nodes fails. > > I can almost get this working fine. But, what I can't seem to figure > out is how to restrict the DRBD Masters to only certain combination of > nodes. > > I want the replication to happen between: > > pzsmbr01 and pzsmbr51 > or > pzsmbr02 and pzsmbr51 > or > pzsmbr01 and pzsmbr52 > or > pzsmbr02 and pzsmbr52
So you the master can only be on 01 and 02? > > Because I share the SAN disks between the following node combinations, I > do NOT want the DRBD Masters to wind up on: > > pzsmbr01 and pzsmbr02 > or > pzsmbr51 and pzsmbr52 > > If there's not an easy way to restrict the MS resource like that and > getting rid of the SAN sharing would make this setup easier, then I'd be > happy to. But, I must have the ability to move a group of resources > around the cluster freely and I don't think I can do that with DRBD > stacking (can I???). I think linbit might be the only ones that can answer that. _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
