Hi,
I am using Pacemaker to configure a 2 node cluster.
The failover seems to be working fine but I would also like the data to go to
both the nodes depending on the load
(i.e. on a round robin basis or transfer the data to another node when load is
increasing).
I am using the following configuration. The data seems to be going only to a
single node when I send from multiple sources.
Can someone suggest any additional changes that is required for the data to be
load balanced in both the nodes.
vagrant@sendervm:~$ sudo crm configure show
node receivervm
node sendervm
primitive p_vip ocf:heartbeat:IPaddr2 \
params ip="10.114.90.251" cidr_netmask="24" nic="eth1"
clusterip_hash="sourceip-sourceport" \
op start interval="0s" timeout="60s" \
op monitor interval="5s" timeout="20s" \
op stop interval="0s" timeout="60s" \
meta migration-threshold="1" failure-timeout="60s"
property $id="cib-bootstrap-options" \
dc-version="1.1.6-9971ebba4494012a93c03b40a2c58ec0eb60f50c" \
cluster-infrastructure="cman" \
stonith-enabled="false" \
no-quorum-policy="ignore" \
default-resource-stickiness="0"
rsc_defaults $id="rsc-options" \
migration_threshold="1"
Thanks and Regards
Hitesh
The information contained in this electronic message and any attachments to
this message are intended for the exclusive use of the addressee(s) and may
contain proprietary, confidential or privileged information. If you are not the
intended recipient, you should not disseminate, distribute or copy this e-mail.
Please notify the sender immediately and destroy all copies of this message and
any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should
check this email and any attachments for the presence of viruses. The company
accepts no liability for any damage caused by any virus transmitted by this
email.
www.wipro.com
_______________________________________________
Linux-HA mailing list
[email protected]
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
