>> Hello, >> >> I'm attempting to use pacemaker/corosync (1.1.10/2.31) in a two node >> active/passive embedded application where all resources should run only on >> one node. I'm looking for a configuration option that will "remember" the >> last active node when the appliance is rebooted. I'm using postgresql >> replication and would like the appliance to always boot to the most recently >> active node!
>Do you mean that after the cluster was completely stopped and starts on both >nodes, you want the application to remember which node it was on prior to the >cluster stopping? That's correct. Sorry, I should have clarified, the two nodes that I'm talking about are in the same appliance connected by a backplane. It seems like I need to set some attribute on a node that can be used in a rule, maybe? ---------------------------------------------------------------------- The information contained in this transmission may be confidential. Any disclosure, copying, or further distribution of confidential information is not permitted unless such privilege is explicitly granted in writing by Quantum. Quantum reserves the right to have electronic communications, including email and attachments, sent across its networks filtered through anti virus and spam software programs and retain such messages in order to comply with applicable data security and retention requirements. Quantum is not responsible for the proper and complete transmission of the substance of this communication or for any delay in its receipt. _______________________________________________ Linux-HA mailing list [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha See also: http://linux-ha.org/ReportingProblems
